Need help?Do you have a question about the Intellian i2 and is the answer not in the manual?
Describes the Intellian i2 as a digital satellite antenna system designed for vessels.
Lists the components that make up the Intellian i2 antenna unit.
Details the components of the antenna unit: Mechanical, Control, RF, and Radome.
Details criteria for choosing an installation location, avoiding obstacles and interference.
Outlines points to consider before installing system cables, including clamping and protection.
Specifies power requirements for the Intellian i2 and the need for AC converters.
Guides on confirming dimensions and space for antenna installation, potentially using a power tower.
Provides the physical dimensions of the Antenna Control Unit (ACU).
Details the cable connections for a single Integrated Receiver/Decoder (IRD).
Explains when and why to adjust the LNB skew angle for optimal signal.
Introduces serial and Wi-Fi methods for PC to ACU communication.
Lists the functions covered in the operation setup section.
Identifies the soft keys on the ACU for operation.
Describes the sequence of operations during the ACU's normal startup.
Describes the default mode for selecting two target satellites.
Explains the mode for targeting three satellites.
Provides instructions on initiating the ACU's setup mode.
Details the process for setting LNB local frequency when using a single band LNB.
Details the process for setting LNB local frequency when using a universal LNB.
Describes Aptus as a next-generation antenna remote control software.
Details the process of installing the Aptus software and its requirements.
Explains how to launch the Aptus software to establish communication.
Describes connecting via a serial port.
Describes connecting via Ethernet or Wi-Fi.
Explains the View tab, User Layout, Layout Manager, Default Layout, and Work View features.
Describes the Connection button for data communication and the Help section for support.
Provides details on GPS, Voltage, Software, and Product Information displayed on the dashboard.
Explains how to view and clear diagnostic error reports.
Guides on how to modify settings within Work View, including Antenna Basic Info.
Provides information on Parameter Setting, Threshold Setting, and Flag Setting.
Displays satellite name, longitude, verification method, and LNB local frequency.
Details dual/triple satellite modes, transponder info, Pol & Band control, and editing satellite data.
Explains how to view signal, elevation, azimuth, and heading information graphically.
Describes the Monitor view for observing data from the ACU, including parameters and debug logs.
Covers running diagnostic tests and configuring network settings.
Details network IP address, subnet, gateway, DNS, and Wi-Fi configuration.
Shows a graphical representation of antenna position and satellite status.
Explains how to arrange and customize the layout of Work View Tabs.
Details how to arrange tabs horizontally/vertically and how to close them.
Describes the zoom tool and view switching functionality within Work View.
To Next Page
General
