Intellian Intelligent Mediator - Page 34

34
Intelligent Mediator – Marine Satellite Communication System
No. Item Description
5
Amp
Information
- S/N: Displays Serial Number.
- S/W Version: Displays Main S/W
Version.
- Amp Name: Sets BUC Name.
6
Set points
Set the control points to BUC.
- High RF Out Alarm: If the RF Output
is more than the setpoint, the Alarm
Error message will detect in the BUC.
- High RF Out Fault: If the RF Output is
more than the setpoint, the Fault Error
message will detect in the BUC and
the Amp state will change to the Fault
state. Click the Reset Fault button
in the Amp Status menu to reset the
Fault status.
- ALC Set Pt: Sets the Max BUC power
Point. The BUC power is amplied
within the Max range. The function is
available when the Power Mode sets
ALC(Automatic Level Control) in the
Amp state menu.
- Manual RF Set Pt: Sets BUC power
level. The function is available when
the Power Mode sets the Manual in
the Amp state menu.
- Attenuation Set Pt: Sets BUC
Attenuator value. BUC power is
attenuated by the setpoint.
No. Item Description
6
Set points
- ALC Disable RF: Sets Limits the use
of the ALC function. If the RF Output
is less than the setpoint, the ALC
function will be deactivated.
7
Cong
(Conguration)
- BUC Unlock Type: Select the BUC
Unlock type.
• ALARM: When BUC is in unlock
state, the Alarm error message will
detect in the BUC.
• FAULT: When BUC is in unlock
state, the Fault error message will
detect in the BUC.
- Band Select: Select the BUC Band
type.
• LOW: Sets BUC Local as Low
Band(26.6GHz).
• HIGH: Sets BUC Local as High
Band(27.2GHz).
8
IP
Settings
- IP Address: Sets BUC IP Address.
- IP Mask: Sets BUC Netmask.
- IP Gateway: Sets BUC Gateway.
NOTE
NOTE: Ensure to tick the checkbox before
modifying the settings. Select ‘Set’ button to
submit the settings.