Interlogix TruVision TVP-3104 - Page 17

TruVision IP PTZ Camera FW 5.1 Configuration Manual 15
Parameters
Description
Default value is 80.
RTSP Port: Specifies the RTSP port. The default port number is 554.
HTTPS Port:
Specifies the HTTPS port. The default port number is 443.
Server Port: Specifies the SDK port. The default port number is 8000.
3.
DDNS
Specifies IP server, DynDNS and ezDDNS.
4.
PPPoE
Use this option to retrieve a dynamic IP address.
5.
SNMP
Enable SNMP to get camera status and parameters related information.
6.
802.1.X
When the feature is enabled, the camera data is secured and user
authentication is needed when connecting the camera to the network.
7.
QoS
Enable to solve the network delay and network congestion by configuring the
priority of data sending.
8.
UPnP
Specifies the UPnP friendly name.
9.
FTP
Specifies the FTP address and folder to which snapshots of the camera
can be
uploaded.
10.
Email
Specifies the email address to which messages are sent when an alarm
occurs.
11.
NAT
A NAT (Network Address Translation) is used for network connection. Select
the port mapping mode: auto or manual.
To define the TCP/IP parameters:
1. From the menu toolbar, click Configuration > Network > TCP/IP.
2. Configure the NIC settings, including the NIC Type, IPv4 settings, IPv6 settings,
MTU settings, and Multicast Address.
3. If the DHCP server is available, check DHCP.
4. If the DNS server settings are required for some applications (e.g., sending email),
you should configure the Preferred DNS Server or Alternate DNS Server.
5. Click Save to save changes.
To define the port parameters:
1. In Configuration > Network > Port.
2. Set the HTTP port, RTSP port, HTTPS port and Server port of the camera.
3. Click Save to save changes.
To define the DDNS parameters:
1. From the menu toolbar, click Configuration > Network > DDNS.
2. Check Enable DDNS to enable this feature.
3. Select DDNS Type. Two options are available: DynDNS and IPServer.
• DynDNS: Enter the user name and password registered to the DynDNS web
site. The domain name is that of the DynDNS web site.
• ezDDNS: Enter the host name. It will automatically register it online.
• IPServer: Enter the address of the IP Server.