58 TruVision IP PTZ Camera FW 5.1 Configuration Manual
To call a preset:
1. Select a defined preset from the list.
2. Click to call the preset.
Using preset tours
A preset tour is a memorized series of preset function. The camera stays at a step for a
set dwell time before moving on to the next step. The steps are defined by presets. A
preset tour can be configured with up to 32 presets.
You can configure up to eight preset tours.
To set a preset tour:
1. In the PTZ control panel, click to enter the tour settings interface.
2. Select a preset tour number from the drop-down list.
3. Click to enter the adding interface of preset.
4. Configure the preset number, preset tour time, and preset tour speed.
reset Tour Time The dwell time. The length of time for which a camera stays at
a preset before moving to the next preset.
reset Tour Speed The speed the camera moves from one preset to another.
5. Click OK to save a preset into the preset tour.
6. Repeat the steps from 3 to 5 to add more presets.
7. Click to save all the patrol settings.
To call a preset tour:
In the PTZ control panel, select a defined preset tour from the drop-down list and
click to call the preset tour.
To Next Page
Loading...
