34 TruVision IP PTZ Camera FW 5.1 Configuration Manual
1. Area Settings: Define the on-screen area that can trigger a motion detection alarm
as well as the detection sensitivity level (see Figure 9, item 1).
2. Arming Schedule: Define the schedule which the system detects and records
motion (see Figure 9, item 2). See “Recording schedule” on page 39 for further
information.
3. Linkage: Specify the method of response to the alarm (see Figure 9, item 3).
To set up motion detection:
1. From the menu toolbar, click Configuration > Events > Motion Detection.
2. Check the Enable Motion Detection box. Check Enable Dynamic Analysis for
Motion if you want to see in live view where the detected motion has occurred.
Note: Deselect the “Enable Motion Detection” option to disable the motion detection
alarm.
3. Click Draw Area. Click and drag the mouse on the live video image to draw an area
sensitive to motion detection.
4. Click Stop Drawing to finish drawing. Click Clear All to delete all areas marked and
restart drawing.
5. Move the Sensitivity slider to set the sensitivity of the detection. All areas will have
the same sensitivity level.
6. Click Edit to edit the arming schedule. The Edit Schedule Time window opens:
7. Select the day and click to set the start and end time periods. You can copy the
schedule to other days or to the whole week. Click OK to save changes.
8. Specify the linkage method when an event occurs. Check one or more response
methods for the system when a motion detection alarm is triggered.
To Next Page
Loading...
