18 TruVision 11/31 Series IP Camera Configuration Manual
2. Select the corresponding version of SNMP: v1, v2c or v3.
3. Configure the SNMP settings. The configuration of the SNMP software should
be the same as the settings you configure here.
4. Click Save to save changes.
Note: Before setting the SNMP, please download the SNMP software and ensure
that you can receive the camera information via the SNMP port. By setting the
Trap Address, the camera can send the alarm event and exception messages to
the surveillance center. The SNMP version you select should be the same as
that of the SNMP software.
To define the QoS parameters:
1. Click Configuration > Network > QoS.
2. Configure the QoS settings, including Video / Audio DSCP, Event / Alarm
DSCP and Management DSCP. The valid value range of the DSCP is 0-63.
The bigger the DSCP value is the higher the priority is.
3. Click Save to save changes.
To define the FTP parameters:
1. Click Configuration > Network > FTP.
To Next Page
Loading...
