TruVision 11/31 Series IP Camera Configuration Manual 47
To format the storage devices:
1. Click Configuration > Storage > Storage Management.
2. Check the HDD Number column to select the storage.
3. Define the quota percentage for snapshots and recordings, modify the values
for each in Percentage of Snapshot and Percentage of Record.
4. Click Format. A window appears to check your formatting permission.
5. Click OK to start formatting.
Recording schedule
You can define a recording schedule for the camera in the “Record Schedule”
window. The recording is saved on to the SD card or NAS in the camera. The
camera’s SD card provides a backup in case of network failure.
The selected recording schedule applies to all alarm types.
Pre-record time
The pre-record time is set to start recording before the event. For example, if an
alarm triggers recording at 10:00, and the pre-record time is set as 5 seconds,
the camera starts to record the event at 9:59:55. The pre-record time can be
configured as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s, or not limited.
Post- record time
The post-record time is set to stop recording after the event. For example, if an
alarm triggered recording ends at 11:00, and the post-record time is set as 5
seconds, the camera records until 11:00:05. The post-record time can be
configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min, or 10 min.
To Next Page
Loading...
