Interlogix TVB-1101 - Tamper-Proof Alarms

TruVision 11/31 Series IP Camera Configuration Manual 35
9. Choose the day and click to set the detailed time period. You can copy the
schedule to other days.
10. Click OK to save changes.
11. Specify the linkage method when an event occurs. Check one or more
response methods for the system when a motion detection alarm is triggered.
Notify Alarm Recipient
Send an exception or alarm signal to remote management
software when an event occurs.
Send Email
Sends an email to a specified address when there is a motion
detection alarm.
Upload Snapshot
Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Trigger Channel
Triggers the recording to start in the camera.
Trigger Alarm Output
Trigger external alarm outputs when an event occurs.
Note: This option is only supported by cameras that support
alarm output.
12. Click Save to save changes.
Tamper-proof alarms
You can configure the camera to trigger an alarm when the lens is covered and
to take an alarm response action.
To set up tamper-proof alarms:
1. Click Configuration > Events > Tamper-proof.
2. Check the Enable Tamper-proof box (1).