TruVision 11/31 Series IP Camera Configuration Manual 45
To set up event-triggered snapshots:
1. Click Configuration > Storage > Snapshot.
2. Check Enable Timing Snapshot to enable continuous snapshots.
3. Select the desired resolution and quality of the snapshot.
4. Enter the time interval between two snapshots. Select the unit of time from the
dropdown list: milliseconds, seconds, minutes, hour, or day.
5. Under Capture Number, enter the total number of snapshots that can be
taken.
6. Click Save to save changes.
NAS settings
You can use a network storage system (NAS) to remotely store recordings
To configure record settings, please ensure that you have the network storage
device within the network. The NAS disk should be available within the network
and correctly configured to store the recorded files, log files, etc.
Notes:
1. Up to eight NAS disks can be connected to the camera.
2. The recommended capacity of NAS should be between 9G and 2T as
otherwise it may cause formatting failure.
To Next Page
Loading...
