Chapter 1 — Introduction
2 Vehicle Power Supply Installation Guide
About the DC Power Supply Kit
The DC power supply kits include these items:
• Power supply
• Power supply input cable, 2.44 m (8 ft)
• Fused power cable, 46 cm (18 inches)
• #10 terminal ring
• 3AB, 20A/250V fuse for 12V installations
• Insulated quick-connect tabs (2)
The power supply provides filtered and regulated 12 VDC
output. This vehicle power supply kit also provides over-current,
over-voltage, over-temperature, and shorted-output protection.
Installation Guidelines
The installer should be familiar with the brands and models of
equipment where this kit is installed, for example the CV60.
They should also be trained and experienced in vehicle electrical
systems.
Installer must follow these guidelines and the installation
procedures as well as those of the lift manufacturer to ensure a
safe and reliable installation.
• Power supply must be securely mounted.
• Mounting surface must be sturdy.
• Mounting surface must provide power supply heat sink.
• Fuse must be close to vehicle power source and be in line with
Intermec equipment only.
• Keep cables as short as possible, and secure them at least every
18 inches (46 cm).
Installation must not violate fork lift manufacturer’s requirements
and should be done by trained professionals.
Chapter 2 details the step-by-step procedure that you will follow
to properly mount the vehicle power supply.
To Next Page
Loading...
Need help?
General
