Chapter 2 — Installation Process
Vehicle Power Supply Installation Guide 25
Cable Clamps
Secure the cables every 18 inches (46 cm) using locking wire ties
or adjustable cable clamps.
To install cable clamps
1 Remove the paper backing from a clamp and adhere the
clamp in place.
2 Drill a pilot hole with a #26 drill bit and use #6 sheet metal
screws to permanently hold each clamp in place.
Recommended Grounding and Power Source Connections
Connecting the Output Power Cable
Once the computer, dock, or other device is mechanically
installed, you can connect the output power cable between the
power supply output and the device. Connectors are keyed and
operate the same as the input power connector.
To finish the connection
1 Mate the cable connector to the power supply and to the
device connectors.
2 Slide the cable connector as far as it will go into the power
supply.
3 Turn the cable connector collar clockwise to secure it.
4 After all connections are secure, connect power to the system.
Note: See “Troubleshooting Charts” on page 32 for
power fault diagnostic information.
#6 sheet metal screw goes here
To Next Page
Loading...
