Chapter 2 — Installation Process
14 Vehicle Power Supply Installation Guide
Preparing the Power Input Cable
Only one of the input connectors will fit the power supply.
To connect the input cable
1 Mate the corresponding cable connector to the power supply
connector.
2 Slide the cable connector in as far as it will go.
3 Turn the cable connector collar clockwise to secure it.
4 Cut the cable at the unused connector end.
5 Discard the unused connector.
6 Remove the cable connector from the power supply with a
counterclockwise turn of the cable connector collar.
Additional details for installation are covered later in the
section “Cable Termination – Overview of Process” on
page 19.
Mounting the Power Supply
The input power cable is approximately 9.0 ft (2.74 m) long and
can be shortened as needed. The output power cable is
approximately 7.0 ft (2.13 m) and should not be lengthened.
h/s tubing, black, 1/8” diameter 321-650-003 12.0” (30.5 cm)
h/s tubing, black, 3/8” diameter 321-650-006 6.0” (15.2 cm)
Ferrite bead 309-065-006 1
Note: The input power cable may be shortened as
needed. It should not be extended on 12V or lower
systems. On higher voltage systems, extensions should
be kept to a minimum and should be of equivalent or
lower gauge (larger diameter) wire. Keep the cable as
short as possible. Extra cable picks up noise, adds
power loss, and is prone to snagging on equipment.
Parts List
Description
Intermec Part
Number
Quantity
To Next Page
Loading...
