Chapter 2 — Installation Process
Vehicle Power Supply Installation Guide 13
4 Shorten cable as appropriate, then crimp the fuse holder to
the joined red and black wires (positive). Crimp a terminal
ring to the joined white and green wires (negative). Insulate as
instructed.
5 Make final connections to the vehicle power source.
Tools Required
• Common hand tools (screwdriver set and pliers)
• Heat gun for heat shrink tubing
• Wire crimping and stripping tool
• Electric drill, drill bits
• DC Ohmmeter
Parts List
Description
Intermec Part
Number
Quantity
Power cable 226-340-004 1
Fuse holder assembly 315-075-003 1
Fuse, 20 A ceramic FB 315-074-003 1
Bolt, 3/8-16 x 1-1/2” 800-099-001 2
Washer, 3/8” 803-099-001 4
Nut, 3/8-16 802-099-001 4
Adjustable wire clamps 808-011-001 8
Self-tap screw #6 x 5/8” 800-008-003 8
3/8” terminal ring 809-165-001 2
#10 terminal ring 809-083-009 3
Self-tab screw #8 x 5/8” 800-012-000 1
#8 flat washer 803-084-000 1
Snap-in bushing 807-065-003 1
Screw, m/s 1/4-20 x 1-1/4” 801-194-002 2
Flat washer, 1/4” 803-100-001 2
Locking nut, 1/4-20 802-117-000 2
Lockwasher, 1/4” 803-042-001 2
Cable tie, locking 808-002-000 6
To Next Page
Loading...
