Intermec EasyCoder 3400e User Manual

EasyCoder 3400e Bar Code Label Printer User’s Manual
HelvC
NugFont
C39
C-6
Note:
Please use caution when replacing control characters with printable characters.
You cannot replace one control character with more than one printable character.
The following table lists the protocol characters that you can redefine and the protocols
they affect:
Character Protocol Affected
SELECT IN POL MODE D, MULTI-DROP
POLL IN POL MODE D, MULTI-DROP
RES IN POL MODE D, MULTI-DROP
REQ IN POL MODE D, MULTI-DROP
SOM IN STD, POL MODE D, MULTI-DROP, XON/XOFF
EOM IN STD, POL MODE D, MULTI-DROP, XON/XOFF
AFF IN POL MODE D, MULTI-DROP
NEG IN POL MODE D, MULTI-DROP
DLE IN STD, POL MODE D, MULTI-DROP, XON/XOFF
XON IN XON/XOFF
XOFF IN XON/XOFF
SELECT OUT MULTI-DROP
POLL OUT MULTI-DROP
RES OUT POL MODE D, MULTI-DROP
REQ OUT POL MODE D, MULTI-DROP
SOM OUT POL MODE D, MULTI-DROP
EOM OUT POL MODE D, MULTI-DROP
AFF OUT POL MODE D, MULTI-DROP
NEG OUT STD, POL MODE D, MULTI-DROP
DLE OUT STD, POL MODE D, MULTI-DROP
XON OUT XON/XOFF
XOFF OUT XON/XOFF
PROTO-CMD 1 STD, XON/XOFF
PROTO-CMD 2 STD, XON/XOFF
TIMEOUT ON EOM POL MODE D, MULTI-DROP

Intermec EasyCoder 3400e Specifications

Cutting Specifications

rating for 0.005-inch paper	1, 000, 000 cuts
rating for 0.010-inch paper	500, 000 cuts
cutting method	Guillotine-type blade

Dimensions and Mounting

adds to printer length	0.5 inch
minimum media width	0.75 inch
maximum media width	4.5 inches

Media Specifications

maximum media thickness	0.010 inch
minimum liner weight	40 lb
minimum cut length	1.0 inch