Intermec easycoder f2 Installation & Operation

Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 1 21
Chapter 5 Ribbon Load
5
Tear-Off, cont.
Remove any empty core from the media supply
roll post.
43
6
Route the media through the print mechanism.
Then push it inwards as far as it will go. This diagram shows the media path.
Fit a new roll of media on the supply post and
adjust the edge guide so the roll becomes fl ush
with the center section.
2
1
4
3
2
1
4
3

Intermec easycoder f2 Specifications

General

Brand	Intermec
Model	easycoder f2
Category	Barcode Reader
Language	English