Intermec EasyCoder PX6i Installation Instructions

EasyLAN Wireless Interface Kit Installation Instructions 47
Chapter 5 — Setup in IPL
Examples:
<STX><SI>ws,WEP1,0x1138170147<ETX>
Sets key #1 (WEP 64, hexadecimal)
<STX><SI>ws,WEP2,Admin<ETX>
Sets key #2 (WEP 64, alphanumerical)
<STX><SI>ws,WEP3,0x123456789abcdef0123456789a<ETX>
Sets key #3 (WEP 128, hexadecimal)
<STX><SI>ws,WEP4,Manufacturing<ETX>
Sets key #4 (WEP 128, alphanumerical)
<STX><SI>ws,WEP2,<ETX>
Removes key #2
<STX><SI>ws,.WEP_KEY,0<ETX>
Disables WEP
<STX><SI>ws,.WEP_KEY,1<ETX>
Select WEP key 1 for use in transmission (0-4 accepted).
<STX><SI>wt,WEP1<ETX>
Transmits WEP key #1 (empty string if that key is not confi gured, “****”
otherwise). WEP2-4 transmits key #2-4.
<STX><SI>wt,.WEP_KEY<ETX>
Transmits selected WEP key: 0 when disabled, 1-4 when enabled. Only
allowed users may see this.
It is not possible for any user to read the WEP key(s).
WEP Enabled/Disabled is shown on the printer web page and the net-
work test label. WEP is deemed disabled if no key has been selected, or if
the selected key is not confi gured.

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g