Intermec EasyCoder PX6i Installation Instructions

EasyLAN Wireless Interface Kit Installation Instructions 5
Chapter 1 — Introduction
For Users Outside of the United States and Canada
 e Intermec product you purchased contains a Mode 802MIG2 trans-
ceiver module.  is module transmits and receives data using a 2.4 GHz
Direct Sequence Spread Spectrum system.
Please check the Intermec web site for additional documentation at
www.intermec.com.
Hereby, Intermec Technologies Corporation declares that this Model
802MIG2 is in compliance with the essential requirements and other
relevant provisions of R&TTE Directive (1995/5/EC).  is product has
been assessed to the following standards:
• ETSI EN 300 328-2 v1.2.1 (2001-12)
• ETSI EN 301 489-17 v1.1.1 (2001-09)
• EN 60950:1992 (incl. Amdt. 1-4,11)
 e original Declaration of Conformity is available on the Intermec
Technologies Corporation web site at www.intermec.com.
 is product transmits electromagnetic waves at 2.4 GHz frequency
range. It has been tested and found compliant with U.S. (OET Guide
65) and Canadian (RSS 102) RF exposure regulations.  ere are no
regulations covering this product type in the European Union at this
time.
 e transmitter module’s output power is 11.6 mW.  e product using
this module are intended for business and industrial environments.  ey
should not be used in residential environments and by children.
 is product is marked with this logo and uses
radio frequency bands that are not harmonized
throughout the European Union.

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g