Chapter 2 — Installing the Forklift Power Supply
PB50 and PW50 Forklift Power Supply Installation Guide 11
4 Shorten cable as appropriate, then crimp the fuse holder to
the joined red and black wires (positive). Crimp a terminal
ring to the joined white and green wires (negative). Insulate as
instructed.
5 Make final connections to the forklift power source.
Tools Required
You will need the following tools to properly install the forklift
power supply:
• Common hand tools (screwdriver, pliers, and so on)
• Heat gun for heat shrink tubing
• Wire crimping and stripping tool
• Electric drill, drill bits
• DC Ohmmeter
Preparing the Power Input Cable
Only one of the input connectors will fit the power supply.
To connect the power input cable
1 Attach the corresponding cable connector to the power supply
connector.
2 Slide the connector in as far as possible.
3 Turn the cable connector collar clockwise to secure it.
4 Cut the cable at the unused connector end.
5 Discard the unused connector.
6 Remove the cable connector from the power supply with a
counterclockwise turn of the cable connector collar.
Additional details for installation are covered later in the
section, “Terminating the Cable” on page 16.
To Next Page
Loading...
Need help?
General
