Chapter 2 — Installing the Forklift Power Supply
14 PB50 and PW50 Forklift Power Supply Installation Guide
Smaller metallic surfaces may be adequate when good air flow is
available or if the portable printer is going to be used in a
refrigerated area. Mountings exposed to direct sunlight may
require more heat sink area.
Using a Standard Power Supply Mount
The installation kit includes the standard hardware for mounting
the power supply. Use mounting Method A when you can easily
access the back side of the mounting location to install a lock nut
and washer. Use mounting Method B where the back side of the
mounting location is inaccessible. Note that this method requires
that the mounting plate be thick enough to accept and retain
sufficient thread to provide a secure and reliable mechanical
installation.
To use mounting Method A
1 Mark and center punch the two mounting holes on the
mounting surface.
2 Use a 1/4-inch drill bit to make the two mounting holes.
3 Use 1/4-inch hex bolts with flat washers and locking nuts to
install the power supply.
To use mounting Method B
1 Mark and center punch the two mounting hole locations on
the mounting surface.
2 Use a #7 drill bit (equal to a hole diameter of 5.1 cm) to make
the mounting holes.
3 Use a 1/4-20 tap to thread the mounting holes.
4 Place a lockwasher on each bolt.
5 Insert the bolt/lockwasher assemblies through the power
supply holes and into the threaded mounting holes.
To Next Page
Loading...
Need help?
General
