Intermec PC23 - Page 170

Appendix B — Default Settings
156 PC23 and PC43 Desktop Printer User Manual
Length (Slow
Mode)
If Media Calibration Mode is set to Slow,
the printer prints the media length plus 10
mm. This value sets an additional amount
of media to be printed. Unit of
measurement is defined in the Unit of
Measurement parameter. Range is 0 to
3200.
0
LTS
Sensitivity
Level
Sets the sensitivity of the label taken sensor.
Range is 0 to 14. Supported when the
Cutter or Label Dispenser accessories are
installed.
0
Power Up
Action
Sets the action when you turn the printer
on:
• No Action
• Formfeed - The printer feeds one label.
• Testfeed - The printer prints a
configuration label.
No Action
Head Down
Action
Sets the action when you close the print
mechanism after opening it:
• No Action
• Formfeed - The printer feeds one label.
• Testfeed - The printer prints a
configuration label.
No Action
Media Settings (Continued)
Setting Description Default