Chapter 1 — About the Printers
22 PC23 and PC43 Desktop Printer User Manual
6 When you see the language you want to use, release .
7 The printer automatically reboots and starts in the command
language you selected.
Mount the Printer on a Wall
You can mount the printers vertically on a wall or other surface. The
printer must be mounted so the media output slot faces down. Use the
following guidelines for selecting a mounting location:
• Choose a location within 1.5 m (5 ft) of an electrical outlet.
• Choose appropriate mounting hardware (not supplied) for
the
mounting surface.
• The
mounting hardware must provide at least 6 mm
(0.25 in) of
clearance between the mounting
surface
and the bottom of the
screw head. The screw head
width should be 6 to 8 mm (0.24 to 0.33
in).
• Intermec recommends that you
use pan-head or flathead screws
with appropriate anchors for drywall, or for cement, concrete
block
, or plasterboard walls. Use wood screws only for wo
oden
surfaces,
and ensure the screw is long enough to be sunk to a
depth
of at least 12.5 mm
(0.5 in).
1 Choose the appropriate wall-mount template for your printer and
use the template to locate and drill holes in the mounting surface.
Caution: Be sure that the mounting surface can safely support the
weight of the printer.
Note: For mounting to wood surfaces, use a drill of 5 to 8 mm (0.2 to
0.3 in), or as appropriate for your mounting hardware.
To Next Page
Loading...
