ZSim v5.XX User‘s Guide 13
length of media will be fed out before printing starts.
A
negative start adjustment means that the specified
length of media will be pulled back before printing
starts.
Default: Printer Model: PF2/4i PM4i PX4/6i PD41
Start Adjust (dots): -100 -100 -133 -80
Default Stop Adjust
Purpose: Determines how much media in [dots] feeds through
after printing is completed. is setting is used to
make sure that the labels are in the correct position
for tear off operation. is value can be either positive
or negative.
A
positive stop adjustment means that the normal
media feed after printing is completed will be
increased by the specified value.
A
negative stop adjustment means that the normal
media feed after printing is completed will be
decreased by the pecified value.
Default:
0 dots
Factory Defaults
Purpose: Sets all of the ZSim program values back to their
original settings.
Feed Action
Purpose: Sets the feed action that occurs at Start Up and When
Head Down. Choices include No Media Feed, Feed
to Web, Media Sensor Calibration, and Set Label
Length.
Default:
Feed to Web
Input Port
Purpose: Sets the type of input port you are using on your
printer. You can set this value to parallel, serial, or
network.
Default:
Network
To Next Page
Loading...
Need help?
General