EasyManua.ls Logo

Interquartz Handset - Demo Mode Functionality; Wideband Audio Settings; Test Tone on OK Key; Handover Feature

Interquartz Handset
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Version 0.4 Page | 28
Demo mode
The demo mode enables constantly backlighting, so be aware of that when this mode is enabled,
backlight saving is disabled and therefore battery consumption will increase.
Wideband
When Wideband mode is enabled (On) the handset supports G722 codec, but to ensure Wideband
audio remember to enable the codec in the base station as well. When Wideband is disabled (Off)
Narrowband codec is used, the option Prefer is not supported at the moment.
Test Tone on OK key
When this feature is enabled (On) a 1 kHz test tone can be put into the audio streaming, e.g. when a
call has been established press the centre key of the handset (where this feature is enabled) and the
test tone is streamed through to the counterpart handset.
Handover
The Handover feature is for Interquartz internal test only (ensure that all settings are set to Off).

Table of Contents

Related product manuals