Interquartz Handset - Installing the Battery; Using the Charger; Handset in the Charger

Version 0.4 Page | 7
Damage Inspection:
The following are the recommended procedure for you to use for inspection:
1. Examine all relevant components for damage.
2. Make a “defective on arrival - DOA” report or RMA to the operator. Do not move the shipping
carton until it has been examined by the operator. The operator/regional representative will
initiate the necessary procedure to process this RMA. They will guide the network
administrator on how to return the damaged package if necessary.
3. If no damage is found then unwrap all the components and dispose of empty
package/carton(s) in accordance with country specific environmental regulations.
Before Using the Phone
Here are the pre-cautions users should read before using the Handset:
Installing the Battery
1. Never dispose of the battery in fires, otherwise it will explode.
2. Never replace the batteries in potentially explosive environments, for e.g. close to
inflammable liquids/ gases.
3. ONLY use approved batteries and chargers from the vendor or operator.
4. Do not disassemble, customize or short circuit the battery
Using the Charger
Each handset is charged through the use of a handset charger. The charger is a compact desktop unit
designed to charge and automatically maintains the correct battery charge levels and voltage. The
charger Handset is powered by AC supply from 110-240VAC that supplies 5.5VDC at 600mA. When
charging the battery for the first time, it is necessary to leave the handset in the charger for at least 10
hours before the battery is fully charged and the handset ready for use.
Handset in the Charger
For correct charging, ensure that the room temperature is between 0°C and 25°C/32°F and 77°F. Do
not place the handset in direct sunlight. The battery has a built-in heat sensor which will stop charging
if the battery temperature is too high.
If the handset is turned off when placed in charger, the handset turns on and shows (shortly) the
charging message “The battery is charging”. After a while the display backlight first dims and then turns
off (if not demo mode is enabled). There will be a response for e.g. incoming calls. If the handset is
turned on when placed in charger, the display shows (shortly) the charging message “The battery is
charging”. After a while the display backlight first dims and then turns off.