7
PART TWO
This Procedure includes the following:
Compressor Initial Setup Checklist
Choosing a Location
Transporting the Compressor
Installing the Power Cord
Connecting the Compressor to the Concentrator
NOTE: DEALERS ONLY - Refer to
DEALER INFORMATION in owners
manual part number, 1100873, BEFORE performing this procedure.
COMPRESSOR INITIAL SETUP CHECKLIST
Before operating the HomeFill II Compressor for the first time, complete
the following checklist:
❑ Choose a location for the compressor.
❑ Transport the compressor to the desired location.
❑ Connect the power cord to the compressor.
❑ Connect the compressor to the concentrator.
CHOOSING A LOCATION
The compressor should be at least three (3) inches away from walls,
draperies or furniture to ensure sufficient air flow.
Avoid placing the compressor next to heaters, radiators or hot air
registers.
DO NOT use in a closet.
The compressor should sit on a hard flat stable surface, such as a table.
INITIAL SETUP PROCEDURE 2
To Next Page
Loading...
