63
8.5.4.2 Adjusting the length of the legrest
WARNING: Danger of injury and danger of damage to the wheelchair if the legrests do not
have sufficient ground clearance!
• Always make sure the legrests have sufficient ground clearance when adjusting the length,
keeping in mind that the necessary ground clearance is increased when overcoming
obstacles!
Pre-requisites:
• 1x Open-ended spanner 13 mm
• Loosen the nut (1) using the 13 mm open-ended
spanner.
• Set the legrest to the desired length. Take care not to
rotate the lower part of the legrest in its support tube.
• Re-tighten the nut.
To Next Page
Loading...
