91
Removing the wheel
• Jack the vehicle up and place a block of wood
underneath it to prop it up.
• Remove the countersunk screw (1) using the
Torx bit.
• Remove the wheel from the axle.
EXPLOSION HAZARD! The wheel will explode if the air pressure is not released from the
tyre before disassembling the wheel rim!
• Always make sure to completely release the air pressure by pressing the pin in the centre of
the valve!
Repairing the flat tyre
• Remove the valve cap.
• Let the air out of the tyre completely by pressing the pin in
the centre of the valve in.
• Remove the 5 cylinder head screws (back of the wheel, 2).
• Remove the rim halves from the tyre.
• Remove the inner tube from the tyre.
• Repair the inner tube and re-fit, or replace it with a new one.
To Next Page
Loading...
