146
Disassembly
• Block up the vehicle (place wooden blocks under
frame).
• Unscrew valve cap.
• Depressurise tyre by pressing in the pin in the valve
(1).
• Unscrew 5 screws (2).
• Remove the wheel rim halves.
• Remove the inner tube from the tyre.
NOTE:
If the old inner tube is to be repaired and re-used, and has become wet during repair, you can
make replacement easier by sprinkling the inner tube with a little talcum powder.
NOTE:
Ensure that the tyre is replaced on the same side and in the same travel direction as it was
previously mounted.
To Next Page
Loading...
