145
12.1.1 Repairing punctures (drive wheel with GB motor and pneumatic tyres)
EXPLOSION HAZARD!
The wheel will explode if you do not let the air out of the tyre before removing the wheel!
• Always let the air out of the tyre before removing it (press in the pin in the middle of the
valve)!
Injury hazard!If the wheel has been insufficiently tightened during assembly, it can
become loosened during driving!
• When reassembling the drive wheels, tighten the Allen screws at a torque of 25 Nm!
Requirements:
• Open-ended spanner 6 mm.
• Torque wrench
• Repair kit for tyre repair or a new inner tube.
• Talcum powder
• Screw blocker Loctite (e.g. Loctite 243)
To Next Page
Loading...
