InMode Without Vasculaze Operator Manual
Section 5: System Operation
After pressing the Hand Trigger as well, the icon will change to Trigger,
and the laser can be emitted to start the treatment.
Lasing is apparent by the blue LED running around the window in the
Handpiece, and by an audio signal.
During treatment, when the laser lightguide is heating up, the System will go
into Cooling Down mode. Wait until the icon changes to Standby mode, as no
energy is delivered in Cooling Down Mode. Press the Standby icon to resume
Ready mode.
System Shutdown
To shut down the System, turn the On-Off Switch located at the front to Off.
Turn the Main Power Switch to Off at the end of the day.
To Next Page
Loading...