EasyManua.ls Logo

Invasix InMode - Treatment Schedule

Default Icon
101 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
InMode Without Vasculaze Operator Manual
Section 7: DiolazeXL Treatment
Information
47 of 96
 In a single mode (Pulse Mode at Off) - move Handpiece to adjacent site and
apply next pulse to cover all treatment area.
 If end-points are not obvious, or if gaps are apparent, perform another pass,
preferably in a different direction, when general erythema subsides.
Occasionally, a third pass on selected sites is applied on light skin. Ensure that
there is a delay of a few minutes between passes (after the whole area is
treated) before applying additional pass.
 Treatment Schedule
The number of treatments typically varies from 4-10 sessions every 4-8 weeks on the
face and every 6-12 weeks on the body.
Lighter and deeper hair is more resistant and requires more treatment sessions.
Hair re-growth should be observed prior the treatment.
Treatment should be concluded when the results are satisfactory to the patient
or according to the physician's discretion.
 Post-Treatment Recommendations
Following each treatment session, the physician should advise the patient on proper
care.
Sun block should be used for 3 weeks following the treatment.
Moisturizer may be applied after each treatment.
Make-up may be applied immediately after facial treatment.
During the first 2 days following treatment, care should be taken to prevent
trauma to the treated area: avoid hot baths, massage, etc. The skin should be
kept clean to avoid contamination or infection. Any mechanical or thermal
damage to the area must be avoided.