InMode Without Vasculaze Operator Manual
Section 8: Lumecca Treatment
Information
Instruct the patient about the safety warnings.
Advise the patient to avoid skin irritation or skin tanning for at least 2 weeks.
Sunscreen is advisable during outdoor activity at daylight hours.
Patient should discontinue any irritant topical agents for 2-3 days prior the
treatment.
Stop anticoagulants 7-10 days prior to treatment, if medically permitted.
Photograph the patient.
Mark the treatment area.
Clean the handpieces parts that come in contact with the skin with 70% alcohol.
The patient may shave the area to be treated. Long and dark hair may
absorb light and leave burn mark on the skin.
Tip Cleaning Instructions Prior to Use
Clean the light guide with 70% alcohol absorbed pad for at least 30 sec.
Leave it for complete drying.
Treatment Recommendations
Follow Device Start-Up Procedure from System Operation section.
Ensure that skin is clean.
Apply thin layer of water-based gel to the treated area.
Prior to using water-based gel, ensure that the container of ultrasound gel
has not passed the expiration date.
Set treatment parameters. Reduce ~20% fluence on thin sensitive skin like
neck or bony area like forehead. Further reduce fluence on thin sensitive skin
over bone like chest and hand dorsum and on off-face, body areas, as well as
on off-face areas, such as arms and legs.
Typical treatment parameters are shown in the table below:
To Next Page
Loading...