Invasix InMode - Pre-Treatment Recommendations

InMode Without Vasculaze Operator Manual
Section 9: Fractora Treatment
Information

58 of 96
Clinical
Indications
Tip
Treatment
Area
RF
Energy
Level
Number
Sessions
Weeks
between
Sessions
Down
Time
Days
Deep
wrinkles,
scars
24
Soft tissue
25-50
1-3
3-6
2-5
Deep
wrinkles,
scars
24
Bony area
20-30
1-3
3-6
1-2
Lax skin
and dark
skin
ablation
24
Coated
Soft tissue
dark skin
up to VI
15-40
1-2
2-3
2-5
Lax skin
and dark
skin
ablation
24
Coated
Bony area
dark skin
up to V
15-25
1-2
2-3
1-2
 The approval and availability of the various Fractora tips may differ in
different countries.
 Always start with a low energy level, test and observe the skin's response
before increasing the energy.
 The deeper the lesion, the higher the energy. However, this consideration is
limited according to patient tolerance, the anesthetic method used, and the
affordable down time.
 On sensitive thin skin area, such as lower eyelid, apply lower parameters with
more passes, rather than higher parameters in one pass. It is also applicable to
any facial area for new users. Use lower energy (~20%) for thin skin like neck or
bony area like forehead. When working on thin skin over bone, such as hand
dorsum or chest, further reduce energy (~20%).
 Do not use higher energy level than 45 energy levels for soft tissue of dark skin
IV-V and reach it gradually in 3-5 sessions with 5 energy levels increments each
session. On bony area of dark skin restrict energy, reaching highest energy
level of 25 energy levels.
 Apply the Fractora Handpiece to the treated area ensuring a contact with
pressure to minimize discomfort, and press Footswitch to deliver RF energy
 Move Handpiece to the adjacent area and press Footswitch again in the
SINGLE mode, or adjust the repetition rate to the speed you move the tip to
adjacent site.