InMode Without Vasculaze Operator Manual
Section 11: BodyFX/MiniFX Treatment
Information
Reduce Pulse Width if bruises appear and with MiniFX restrict Pulse Width to
1-3sec.
Divide treatment area to zones of about the size of a large hand palm, 4 foot-
prints of the Vacuum Chamber (full normal size abdomen = 6 treatment
zones), and 3-4 foot-prints for MiniFX. Mark the treatment area and zones. The
smaller the zone and the thinner the fat, the lower the RF Power.
Assume a full contact of Handpiece with skin with a slight pressure to enable
vacuum.
Use your free hand to flatten and stretch treatment area.
Press the Footswitch and initiate the RF energy and suction, and dwell on the
site for preset pulse duration.
Move to adjacent site with no overlap from previous site and apply another
pulse.
When skin utes. min30 -15Apply multiple passes to the treated zone during
more minutes of treatment. 3-C, compensate with 1
o
41<temperature is
Stacking pulses in the first and second passes may shorten the heating time to
reach the cut-off temperature.
For the next 15-30 minutes, the longer – the better, move around the zone
evenly, maintaining cut-off temperature. Please note that time is measured
once the cut-off temperature has been reached.
Excessive heat sensation after a few passes may call for a faster movement,
reduced pulse width, reduced RF power level, and last, reduced cut-off
temperature, in this sequence.
After 15-30 minutes move to the next zone, usually left or right side, and
perform the same steps.
Some patients who cannot tolerate the heat may have the treatment time
divided into two – e.g. for full 20 minutes total time may be divided to 10 + 10
minutes, allowing the skin to cool down. One zone is then treated for 10
minutes and the other zone (left or right) is treated for 10 minutes. After
treating the second zone for 10 minutes return to the first zone and complete
additional 10 minutes. Repeat treatment of the second zone. Each zone is
treated for a total time of 20 minutes. In odd areas like navel area or neck,
allow skin cooling between repeated treatments, especially in small areas.
After treating the zone, move to the next zone.
Asian skin is typically thicker and more fibrotic than Caucasian skin, hence
occasionally higher energy, smaller zones, longer treatment and more
sessions (all or part of these measures) may be required.
To Next Page
Loading...