Invasix InMode - Page 88

InMode Without Vasculaze Operator Manual
Section13: Troubleshooting

83 of 96
Section13: Troubleshooting
The InMode System provides monitoring of all critical parameters to ensure safety of
patient and user. If any of the following faults are detected system automatically
goes to Stand By mode.
 Description of Faults with All Handpieces
Problem
Description and Checks
The System did not turn on
 Check the Power Cord connection.
 Check that the Main Switch on Rear Panel is On.
 Check that the On/Off Switch on Front Panel is On.
 Check that the Emergency Button has not been
pressed.
 Check the fuses on the Back Panel of the System.
 Call Technical Service if the problem persists.
The System shuts down by
itself
 Check the Power Cord connection.
 Check the fuses on the Back Panel of the System.
 Check that the Emergency Button has not been
pressed.
 Call Technical Service if the problem persists.
Checksum
 The software was not loaded properly from the
Software Plug.
 Check the Plug connection and reboot the System.
 Call Technical Service if the problem persists.
Fault H8002 - Handpiece is
not connected
 Check the Handpiece connection.
 Replace the Handpiece.
 Call Technical Service if the problem persists.
Fault H8005, H800F, H8010
– System Memory Fault
Call Technical Service if the problem persists.
Fault H8601 – Distributor
Card Connection Fault
Call Technical Service if the problem persists.
Fault H8609 – Water
Temperature Fault
Call Technical Service if the problem persists.