4.6 Hotspot Page
In this page, you can modify the name of the Wi-Fi hotspot that your InvizBox Go creates (default value
being InvizBoxGo which you've experienced throughout the initial setup process). You can also deal with
some settings for the WiFi hotspot.
You can also modify the password used to connect to that Wi-Fi hotspot (default value was provided to
you on a card with your InvizBox Go device).
Once you have entered your a new value for one or both of those fields, click Save to update your
credentials (those modified values will be forgotten following a reset and would have to be entered
manually again - do not lose your original card).
Important Note: every time a new password is set in this page, the administrator password will also be set
to that value (That administrator password can subsequently be changed to a different value in the
Administration Page).
Checking 'Hidden SSID' will hide the WiFi hotspot. Devices will then only be able to connect by entering
the hotspot name and password on their device as it will not show up in WiFi scans.
Checking 'Wireless Isolation' will isolate devices connected to the hotspot so that they are not able to see
each other.
Section 4.6 Hotspot Page Page 17
To Next Page
Loading...
Need help?
General
