3.2 Choose Network Page
In this page, you have to select a network to connect to.
The InvizBox Go will perform a scan of all networks available to you and list them in order of how strong
their signal is. It also adds information regarding the fact that these networks require a password or not.
There is a green refresh icon beside the networks which can be clicked to perform another scan for
networks if the network you're looking for is not in the list.
As the InvizBox Go scans for networks, your device may disconnect you. If this is the case, simply
reconnect to the InvizBox Go WiFi hotspot to continue.
After having selected your network of choice, you will be prompted to enter its password. No passwords
are required for "Open" networks.
You can also select "Connect to Hidden Network" and enter the name of the network to connect to a
hidden network.
Once you have chosen a network and (if necessary) entered the password for it, click Finish to go to the
final wizard page.
If you have entered in the wrong password on this page, then you will need to connect to the network
again once you have finished the wizard. This can be done by returning to the "Choose Network" page of
the Administration Interface in the InvizBox Go section of the menu.
Page 8 Section 3.2 Choose Network Page
To Next Page
Loading...
Need help?
General
