EasyManuals Logo
Home>INVT>Inverter>BD-RH1 Series

INVT BD-RH1 Series User Manual

INVT BD-RH1 Series
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
Not in potential explosive areas.
Not in the cool air directly.
Not near the television antenna or antenna cable.
Not higher than altitude of about 2000m above sea level.
Not in environment of precipitation or humidity (95%).
Under good ventilation condition.
The ambient temperature in the range of -20℃ to +60℃.
The slope of the wall should be within ±.
The wall hanging the inverter should meet conditions below:
1) Solid brick/concrete, or strength equivalent mounting surface;
2) Inverter must be supported or strengthened if the walls strength isnt enough
(such as wooden wall, the wall covered by thick layer of decoration)
Please AVOIDE direct sunlight, rain exposure, snow laying up during installation and
operation.
4.3.2 Space Requirement
4.3.3 Mounting
Tools required for installation.
Installation tools: crimping pliers for binding post and RJ 45, screwdriver, manual wrench
etc.
Position
Min. size
Left
300mm
Right
300mm
Top
300mm
Bottom
300mm
Front
300mm
300mm
300mm
300mm
300mm

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the INVT BD-RH1 Series and is the answer not in the manual?

INVT BD-RH1 Series Specifications

General IconGeneral
BrandINVT
ModelBD-RH1 Series
CategoryInverter
LanguageEnglish

Related product manuals