INVT CHV160A Series - Page 73

C.TY TNHH TỰ ĐỘNG HÓA VIỆT TRUNG 02413.281.181-
0989.984.666
Website:www.viet-trung.com.vn Đ/c:194-Nguyễn Trãi-Võ Cường-
TP.Bắc Ninh
1: Enabled: W hen inverter is running, after power off and power on again, if run command
source is keypad control (P0.00=0) or communication control (P0.00=2), inverter will
automatically restart after delay time determined by P1.15; if run command source is
terminal control (P0.00=1), inverter will automatically restart after delay time determined
by P1.15 only if FW D or REV is active.
Function
Code
Name Description
Setting
Range
Factory
Setting
P1.16
Notice:
FW D/REV ENABLE
0: Disabled
1: Enabled
0~1 0
 This function only takes effect if run command source is terminal control.
 If P1.16 is set to be 0, when power on, inverter will not start even if FWD/REV
terminal is active, until FWD/REV terminal disabled and enabled again.
 If P1.16 is set to be 1, when power on and FWD/REV terminal is active,
inverter will start automatically.
 This function may cause the inverter restart automatically, please be