iMars grid-tied solar inverters Display panel
52
6.4.5 System Information
Press “ ” and “ ” in the main interface to select “System Information”, and then press “ENT” to
view the parameters which is shown in figure 6.8.
System Information
Part No .
Serial No .
Soft Ver
Cert . Area
Run Param
Figure 6.8 System information
The system information include “product model”, “serial No.”, “software version” and “certificate
version”.
Sy s t e m V e r
Ve r s i on1 : V 1 . 05
Ve r s i on2 : V 1 . 05
MC U V ers i o n : V 1 .05
Figure 6.9 System version
6.4.6 Faults
Press “ ” and “ ” in the main interface to review the fault history, and then press “ENT” to view
the sub-menu which is shown in figure 6.10.
Fa u l t
1: A 0 05 G r id u n d er f r e q
2: A 0 01 I n put u n der V o lt
3:
1
Figure 6.10 Fault information
There are 8 pieces of fault information in the record which is shown in figure 5.10; otherwise it will
display “No Fault!” Refer to section 6.4.2 for more detailed information.
6.4.7 Inverter control
Press “ ” and “ ” in the control interface, and then press “ENT” to view the sub-menu which is
shown in figure 6.11.
Co n t r ol M e n u
On / O f f
Clear
Re s t a rt
Fa c t o ry
Figure 6.11 Control interface
Refer to the table below for detailed information.
To Next Page
Loading...
Need help?
General