Force device to restart. Configurations will be erased
after Reboot. So please do save them before you restart
the switch.
Display and allow you to config basic port parameters,
such as link status, speed/duplex, MAC address
learning, flow control (enabled by default) and
broadcast storm control (enabled by default), etc.
Display and allow you to config port mirroring settings.
Aggregation enabled or STP enabled port cannot be
configured as a mirroring destination port.
Display the number of packets transmitted and received
on corresponding ports. Statistics info will be cleared
automatically if statistic mode is changed.
Display and allow you to config port rate limit settings
Provide 3 groups of aggregation and 4 algorithms to
increase bandwidth and implement load balancing.
a).Configure power management mode (The default is
Dynamic Allocation);
b). View Current Power Utilization and PSE
Temperature.
a). Configure PoE status, PoE standard, priority and
static power allocation;
b). View the amount of power supplied to connected
PDs and PD class.
Display port VLAN configurations.
Display 802.1Q VLAN configurations.
Display and allow configuring PVID and tagging
settings on the port.
Configure MAC address binding feature
Configure STP global settings (enable/disable STP, STP
version, system priority, Hello Time, delay, Max age
time), loopback detection settings (enable/disable
To Next Page
Loading...