EasyManua.ls Logo

Iridium Pilot - Section III - System Configuration; System Configuration; Network Configuration

Iridium Pilot
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3: SyStem CONFIGURAtION
Iridium Pilot User Manual 15
Section III – SYSTEM CONFIGURATION
3.0SystemConguration
Conguring the system and full diagnostics can only be done by the System Administrator and requires a login
password. The default user name and password is admin. Change the password if desired.
3.1NetworkConguration
Conguration of LAN Settings
The Iridium Pilot Terminal allows you to congure the following LAN settings, via the web pages when logged
on as admin’. These settings include:
• IPAddress
• SubnetMask
• DHCPServerandIPAddressRangetoUse
• DNSForwarding
IP Address
This is the IP address of the Iridium Pilot unit as seen from the vessel. The factory default is 192.168.0.1. You
should not change this default unless there is already LAN equipment on the vessel, in which case you must
set this to an unused IP address of ship-side LAN.
Subnet Mask
This denes the subnet used on the vessel. The factory default is 255.255.255.0. You should only change this
default if you change the IP address of the Iridium Pilot unit. All network devices must use the same subnet in
order to communicate with one another.
DynamicHostCongurationProtocol(DHCP)server
This automatically provides unique IP addresses and appropriate conguration parameters to each network
device connected to the Iridium Pilot unit. In the current conguration, DHCP is disabled.
Note: While DHCP is disabled, devices connected to the Iridium Pilot unit will need to have their network
settings manually congured. There must only be one DHCP server on any network segment. Please see insert
on“howtocongurenetworkconnectionsmanuallywithWindows®.
DHCP IP Address minimum and maximum
This sets the range of IP addresses for the DHCP server to use. The factory default is 192.168.0.2 to
192.168.0.254. The range species the maximum number of devices on the network. Both the maximum and
minimum value must be in the same subnet.

Other manuals for Iridium Pilot

Related product manuals