Iskra PFC max 6 User Manual

User's manual
PFC max 6, PFC max 12 Page 11
3.5.1 Key functions in normal RUN status
Key to enter set-up mode: After a long push (> 1s) of this key, the device will enter
the set-up mode, and will accept configuration changes.
Manual connection of capacitor stages: If this key is pushed for more than 1s, the
regulator starts connecting new steps in a sequential mode, respecting the adjusted
connection times, t
on
Manual disconnection of capacitor stages: If this key is pushed for more than 1s,
the regulator starts disconnecting steps in a sequential mode, respecting the
adjusted disconnection times, t
off
3.5.2 Key functions in SET-UP status
Long Push (>1s): This is to initiate or exit the set-up mode. Exiting the set-up mode
with a long push (>1s) will automatically save the changed parameters. Exiting with a
short push will not save the changes.
Long Push (<1s): This is used to initiate or exit the different set-up sub-menu
options (different configurable parameters). Warning! The new programmed values
are not saved unless a long push of this key (>1s) is used to exit the set-up menu.
Upwards navigation in the menu options available in the set-up menu.
Increment of numerical values inside the set-up sub-menus.
Downwards navigation in the menu options available in the set-up menu.
Decrement of numerical values inside the set-up sub-menus.
Change the digit to be edited in case of numerical values with more than one digit.

Iskra PFC max 6 Specifications

General

Brand	Iskra
Model	PFC max 6
Category	Controller
Language	English