User's manual
PFC max 6, PFC max 12 Page 2
Index
1. INTRODUCTION AND SAFETY RECOMMENDATIONS ............................................................... 4
1.1 Delivery spot check ............................................................................................................... 5
1.2 Starting screen ...................................................................................................................... 5
1.3 Definitions ............................................................................................................................. 5
1.3.1 Four quadrant regulators ............................................................................................. 6
1.3.2 FCP program (FAST PFCized Program) ..................................................................... 6
1.3.3 Stages and steps......................................................................................................... 6
1.3.4 Stages ratio program ................................................................................................... 6
2. GENERAL CHARACTERISTICS ................................................................................................... 7
3. FRONT PANEL: SCREEN and KEYBOARD ................................................................................. 8
3.1 Display screen ...................................................................................................................... 9
3.2 Measured parameters ........................................................................................................... 9
3.3 Errors and ERROR messages .............................................................................................. 9
3.4 Alarm relay.......................................................................................................................... 10
3.5 Regulator status and key functions ..................................................................................... 10
PFC max regulators have two possible status. .................................................................................. 10
3.5.1 Key functions in normal RUN status .......................................................................... 11
3.5.2 Key functions in SET-UP status ................................................................................. 11
4. INSTALLATION AND START UP ................................................................................................ 12
4.1 Technical Characteristics .................................................................................................... 12
4.2 DEVICE INSTALLATION .................................................................................................... 13
4.2.1 Mechanical Installation .............................................................................................. 13
4.2.2 Connections .............................................................................................................. 13
4.2.3 Cabling cross sections and protections ...................................................................... 14