IST 18.BF200D - Page 26

18-26
18. BF200D • BF225D • BF250D iST
®
14. Install the under case grommet into the engine
under case by aligning the groove with the
tab.
15. Install the separate cover over the under case
grommet and onto the engine under case by
aligning the groove with the tab.
Install the two 6 x 25 mm flange bolts and
tighten evenly to the specified torque.
TORQUE: 5 N•m (44 in-lb)
NOTICE
Do not over tighten the flange bolts. This
could damage the ferrules.
NOTE: All the cables and harness must be
routed through the separate cover before con-
necting the control cables. This routing cannot
be done after the control cables are con-
nected.
UNDER CASE
GROMMET
GROOVE
ENGINE UNDER CASE
TAB
6 x 25 mm
FLANGE BOLT (2)
ENGINE
UNDER CASE
SEPARATE
COVER
GROOVE TAB
FERRULE