8. How to set the Timeout Lock in User mode
To protect against unauthorised access when the datAshur Pro is connected to a host and unattended, the datAshur Pro can
be set to automatically lock after a pre-set amount of time.
In its default state, the datAshur Pro Timeout Lock feature is turned off. The Timeout Lock feature can be set to activate (lock)
anywhere between 1 and 99 minutes.
To set the Timeout Lock, please follow steps in the table below.
Instructions LED LED State
1. Unlock the datAshur Pro with User PIN
Red solid LED changing to Green solid LED
indicating successful User PIN entry
2. Enable Options by pressing the KEY button 3 times -
treble click
&
Green and Blue LED’s blinking together
awaiting new instructions in OPTIONS mode.
3. Within 10 seconds begin to Press button number 8
(Tuv) followed by the number 5 (jkL) button - (85)
&
Green and Blue LED’s continue to blink together
4. Press KEY button once
Blinking Green LED
5. Within 10 seconds begin enter the length of User
Timeout in 2 digits:
00 = 0 minutes (default)
01 = 1 minute
99 = 99 minutes etc
Green LED continues to blink
6. Press the Key button once
Green solid LED - Admin can override USER
Timeout Lock
9. How to disable the Timeout Lock in User Mode
Instructions LED LED State
1. Unlock the datAshur Pro with User PIN
Red solid LED changing to Green solid LED
indicating successful User PIN entry
2. Enable Options by pressing the KEY button 3 times -
treble click
&
Green and Blue LED’s blinking together
awaiting new instructions in OPTIONS mode.
3. Within 10 seconds begin to Press button number 8
(Tuv) followed by the number 5 (jkL) button - (85)
&
Green and Blue LED’s continue to blink together
4. Press KEY button once
Blinking Green LED
5. Within 10 seconds begin to press the number 0 button
twice (double click) (zero,zero)-(00)
Green LED continues to blink
6. Press the Key button once
Green solid LED - Timeout Lock has been
disabled
To disable the Timeout Lock, please follow steps in the table below.
To Next Page
Loading...
