ENGINE MECHANICAL 6A–55
1. Use the oil seal installer 5-8840-2627-0 to install the
oil seals to the cylinder head.
2. Tighten the engine hangers to the specified torque.
Torque: 48 N·m (4.9 kgm/35 lbft)
3. Install the bridge guides to the cylinder head.
1. Apply engine oil to the valve bridge guide outer
circumference.
2. Attach the valve bridge guide installer 5-8840-
2626-0 to the bridge guide.
3. Use a brass hammer to tap the guide into position
from the cylinder head upper face.
011MX026
011MX036
011MX044
To Next Page
Loading...
