To Next Page

To Previous Page

Display Commands

Chapter4 Display Commands

DISPlay

This order is used to turn on/off the VFD display. When the display is off, the

output and will not be displayed on the VFD, at the same time, all the LED

except for ERROR led will not be off. When the control mode is local, the

display will turn on automatically, press LOCAL button can switch the control

mode from remote to local.

Order syntax:

DISPlay[:WINDow][:STATe] <bool>

Parameter:

0|1|OFF|ON

Example:

DISPlay 1

Quest syntax:

DISPlay?

Returned parameter:

0|1

DISPlay:TEXT < Reference value>

This order is used to display a text on the VFD. TA message can display up

to 12 characters, extra characters will be ignored. Commas, periods and

semicolons will not be treated as a separate character but will be

contained to the character before and display.

Order syntax:

DISPlay[:WINDow]:TEXT[:DTAT]

Quest syntax:

DISPlay:TEXT?

DISPlay:TEXT:CLEar

This order is used to clear the text displayed on the front panel.

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT6952A Programming Guide

Other manuals for ITech IT6952A