ITech IT6952A - Chapter12 IEEE488.2 Commands; Cls; Ese

IEEE488.2 Commands
Copyright ©ITECH Electronic Co., Ltd. 41
Chapter12 IEEE488.2 Commands
*CLS
This order can clean the register as follows:
 Standard event status register
 Quest condition register
 Status byte register
Order syntax:
*CLS
Parameter:
None
*ESE
This order can set the parameter of standard event enable register. Setting
parameter can determine which bit value of standard event register is 1 and the
byte will enable ESB of status byte register is 1.
Order syntax:
*ESE <NR1>
Parameter:
0~255
Reset value:
Consult *PSC order
Example:
*ESE 128
Quest syntax:
*ESE?
Return parameter:
<NR1>
Reference order:
*ESR? *PSC *STB?
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com