ITech IT6952A - List:current; List:timer

List Commands
Copyright ©ITECH Electronic Co., Ltd. 38
Example:
LIST:VOLT 1, 3V //set the first step’s voltage to be 3V
Query syntax:
LIST:VOLTage?
Example:
LIST:VOLT? 1 //inquire the first step’s voltage
Return parameters:
<NR2>
LIST:CURRent
This order is used to set the steps of list file and current value of current step.
Order syntax:
[SOURce:]LIST:CURRent <NRf>
Parameters:
MIN~MAX
Unit:
A
Example:
LIST:CURR 1, 2A // set the first step’s current to be 2A
Query syntax:
LIST:CURRent?
Example:
LIST:CURR? 1 // inquire the first step’s current
Return parameters:
<NR2>
LIST:TIMEr
This order is used to set the steps of list file and delay time of current step. This
order is used to set delay time of every steps.
Order syntax:
[SOURce:]LIST:TIMEr
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com